Making Adjustable-Fit Miter Bars for a Crosscut Sled

0:07 I used a steel ruler to mark two parallel lines on either side of the blade From these marks I measured and drew two the mitre slot lines 0:48 After

These solid aluminum miter bars from Rockler have nylon set screws that adjust in or out for a perfect fit in any standard 34'' x 38'' miter slot

miter slot runners My miter slots are 38″ deep, by 34″ wide This is basically standard, but it does vary It depends on your table saw's brand Many small table saws have what

miter slot track But if yours do, you can rub the sides of your miter slots with a wide carpenter's pencil then slide the runners along the miter slots a few