fret slot depth
Depth Stop for Fret Slotting Saw
fret slot depth
website fret slot depth This is a handy addition for your Pax fret saw Use it to set a maximum cutting depth so that the fret slots in your guitar fretboard are all at the exact fret slot saw It shows you if the fret slot will accept the fret wire that you're about to use What you do is put the fret tang up to these two mark lines The lower line is
fret slot depth Fret slotting saw giving a kerf of inches, for cutting fret slots in a guitar fingerboard Complete with a perspex guide to control the depth Stewmac, Fret Slot Depth Gauge Don't wait until after you've installed a fret to discover the slot wasn't quite deep enough! Dan Erlewine developed this Based on the rumor that Polymet makes their fret wire I found that all but two SM options have an identical Polymet match and their tang width